elastic modulus

The simultaneous measurement of the tensile strength, yield strength, stretching rate, elastic modulus, peel strength and power-of time, of a displacement curve.

可同时测量材料的抗拉强度、屈服强度、伸缩率、弹性模量、剥离强度及力-时间，力一位移曲线。

There are the relationship between elastic modulus and phase-speed and surface-displacement of Lamb wave.

随着弹性模量的变化,兰姆波相速度和表面位移场与弹性模量之间有一定的对应关系.

The results showed that the notched Izod impact strength and conservation rate of tensile yield stress of HDPE E-TMB were markedly superior to those of HDPE elastomer, while the conservation rate of elastic modulus in bending of HDPE E-TMB and HDPE elastomer was nearly the same.

结果表明，HDPE/ETMB的悬臂梁缺口冲击强度的提高幅度、拉伸屈服应力保持率均显著优于HDPE/弹性体，二者的弯曲弹性模量保持率基本相同；

Stem stiffness depends the elastic modulus the material and to the fourth power of the diameter.

假体柄的刚度由制备材料的弹性模量决定且与直径的4次方成正比.

Effective Digit of Elastic Modulus in Tensile Test of Metal Materials

金属材料拉伸试验中弹性模量的有效位数

It is clear that increases adherend thickness or Poisson ratio as well as decreases the elastic modulus may decrease the peck value of Von Mises equivalent stress.

分析可知：高的泊松比、低弹性模量和被粘物厚的增大会使得VON MISES等效应力值显著降低。

The results showed that the critical fracture load of passive films reduced and the displacement excursion decreased with increasing the concentration of hydrogen. The reduction of radial breaking stress and elastic modulus of passive films is attributed to that hydrogen changes the structure of passive films.

结果表明：随氢含量的增加，不锈钢钝化膜的临界破裂载荷降低，位移偏移量减小，氢导致钝化膜的径向抗拉强度（应力）和弹性模量降低，钝化膜随氢含量的增加而逐渐软化。

The test results show that the longer the time of moist curing, the higher the values of compressive strength, splitting tensile strength, elastic modulus and critical stress intensity factor.

试验结果表明，抗压强度、弹性模量、抗拉强度以及临界应力强度因子随标准养护时间的增长而增大，弹性模量对养护条件的敏感性最大。

The larger the elastic modulus, the greater the stress needed for a given strain.

弹性模量越大, 产生一定应变所需要的应力也越大.

By contrast, under tension, the elastic modulus of hard rock is relatively large at the beginning stage and then decreases with loading.

而单轴拉伸下，硬岩的弹性模量初始较大，随后随着载荷增大而逐渐减小。

The third moment creep will occur when the generalized elastic modulus is less than zero.

广义弹性模量小于零时,对应第三阶段蠕变.

To enhance thermal-wear resistance of the mandrel, it is required to use mandrel material which has dispersed carbide, linear expansion factor of the base metal close to that of the chide film, minimum elastic modulus and maximum thermal conductivity factor.

为了提高芯棒的抗热损伤性能，应使芯棒材料的碳化物弥散化，基体金属与氧化膜的线胀系数相接近，弹性模量尽量低，热传导系数尽量高。

The elastic modulus is a measure of the resistance of a material to deformation under load.

弹性模量是材料在受到负荷变形时产生的阻力的衡量.

The equivalent elastic modulus was deduced by comprehensive considering deflection and elastic modulus.

通过综合考虑挠度引起弹性模量和弹性伸长引起弹性模量推导出等效弹性模量.

The objective of this experiment is to measure the Elastic Modulus of steel.

实验目的是测量钢的弹性模量.

Inversion of Elastic Modulus of Thin Plate Using Acoustic Pressure Transmitting Coefficient Spectrum

应用超声声压透射系数谱反演薄板的弹性模量

Research on Testing the Quality of Rock Mass with Boring Elastic Modulus Instrument and Acoustic Wave Instrument

钻孔弹模计及声波仪检测岩体质量的试验研究

Meanwhile, the influences of lime dosage ratio, consolidation ratio, and frequency on elastic modulus were investigated.

同时还针对掺灰比、固结比以及频率等影响因素进行了深入研究，得出了下列的结论：石灰土的动弹模量随应变水平的变化规律与粘土基本一致；

The various types of stress, strain, and elastic modulus are summarized in Table 10-3 .

各种应力 、 应变和弹性模量列于表 10-3 中.

It has been proved by the investigation that the filling effect of the confined expansion makes the reduction of holes in concrete as well as the increase of strength and elastic modulus of concrete.

实验证明：由于约束膨胀的填充作用，大幅度降低空隙率及孔径，定将有效地提高混凝土的弹性模量及强度。

Confining pressure have different influence on strength elastic modulus and damage form obviously.

在围压相同情况下,岩石的蠕变损伤与扰动冲击荷载能量有关.

An empirical equation describing the relationship of elastic modulus and compressive strength of RAC is obtained.

建立了再生骨料混凝土弹性模量与立方体抗压强度的相关关系式.

An elastic modulus of single voxel was measured and analyzed measure physical properties of materials.

提出了一种飞秒激光双光子成型点弹性模量的测量及结果分析方法.

With equivalent hydraulic model developed , elastic modulus of fractured rock may be modified with fracture properties.

在物理力学参数的确定中,考虑了裂隙 、 溶洞对岩体弹性模量的影响.

The results show that the maximum elastic specific energy in the wall of coal roadway is almost directly proportional to the square of digging depth and almost inverse proportional to the elastic modulus.

结果表明，煤层巷道两帮煤体中弹性比能的最大值与采深的平方近似成正比，与其弹性模量近似成反比。

Consequently a new reliably approach to identify dynamic elastic modulus of damand that of rock basement.

本文的方法也适用于一般结构的振动参数识别问题的求解.

Parametric studies show that the axial elastic modulus of the composites increases with increasing the linear density ratio of axial yarn to braider yarns and pitch length.

参数分析结果表明，轴向弹性模量随轴纱与编织纱线密度之比和节距长度的增加呈增加趋势。

The hooping mechanism coefficient, theoretic formulas of the composite axis pressed elastic modulus were gained.

理论计算公式能够准确可靠地描述钢管混凝土构件在小变形下的弹性行为及套箍机理.

The elastic modulus, tensile yield stress, fracture stress, and elongation of n Cu are 0.65, 1.42, 1.82 and 0.15 times of that of p Cu, respectively.

纳米铜的弹性模量、屈服强度、断裂强度和延伸率分别为多晶粗晶铜的0.65,1.42,1.82和0.15倍。

The elastic modulus and the plastic properties are affected by the dissolution process.

弹性模量和塑性参数受溶解过程的影响.